If anyone knows how this can be done I would be very grateful for a few pointers or maybe it would be better to get them coded by the stealer. I am told its possible to code the new LED clusters with VCDS but I guess this will be in the dreaded byte 18 and to be honest I am very apprehensive to play around with byte 18 in case I end up with a mess I cannot get out of or worse damage my BCM. I am not too sure resistors are the way to go as Yetis have 2 x 21w standard tail bulbs in each side and ohms law works it out that I will need a 36w 4ohm load resistor which are available in 50w units to make up the missing current draw as the LEDS for back driving lights only draw 400ma which is 6w. The usual problems occur with bulb failure warnings even though everything works great. I have a couple of new sets of LED clusters and I have a 2014 Yeti, the lights are a direct replacement and connecting plugs are the same. Does anyone know or had dealings with replacing normal rear light clusters for the new LED units.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |